top of page
Mounting Information
Mount Block Removal
1
The mounting block is connected to the Allegro Hand using six (6) M3 flat-head screws (3 on each side).
2
'Remove three (3) screws on either side of the hand. Do NOT remove the two (2) screws labeled A or the corresponding screws on the other side of the hand.
Note: Secure the hand while unscrewing the mounting block to avoid dropping the hand once disconnected.
3
Once the six (6) screws have been removed, the mounting block can be removed from the bottom of the hand.
Mounting
The block can be mounted to a surface using six (6) M3 socket-head cap screws.
Reassembly
Place the hand onto the mounting block and replace the six (6) M3 flat-head screws (3 on each side).
Note: The hand should be mounted to a raised area so as to avoid thumb-mount interference during hand movement.
Mount Block Dimensions
Version 4.x
<All dimensions are displayed in millimeters (mm) and degrees>
bottom of page